ENGINEERING.com has updated it's forum.  To post a question please visit the new Ask@ Forum.   

With a database of over 10000 questions the library will remain available for an extended period.

Q&A


PULAOKHAO
Is there a lower limit to the gland surface finish for static O-rings, gaseous system? View All
"O-rings" article by "The Engineer" on 10-23-06

http://www.engineering.com/Library/ArticlesPage/tabid/85/articleType/ArticleView/articleId/132/O-rings.aspx

surface finish table lists 0.41-0.81 micro-meters for static gaseous systems. What is the drawback of using a smoother surface finish lower than 0.41?


5 years ago - 3 months left to answer. - 1 response - Report Abuse
Respond to question
    0      [lnkReport]        0       0       
Share |
  Responses


Niel
There is no specific limit to the lowest surface roughness you can use on for sealing O-rings. The disadvantage to a higher quality surface finish than necessary is cost. Note - dynamic seals have a better surface finish in general when compared to static seals.

The limits given would indicate that you do not get any improved performance by improving your finish.

If you have a lower quality finish you either get more wear or a lower quality seal.

Niel Leon
engineering.com


5 years ago

Source:


  0     0         

ENGINEERING.com does not provide engineering advice. The Ask@ service is a forum for members to exchange ideas relating to the world of engineering. We caution users not to accept any responses that they receive without further validation, and not to rely on any engineering advice that they may get from other members of the Ask@ forum. ENGINEERING.com specifically disclaims any obligation to validate or verify any information posted within the Ask@ service. ENGINEERING.com encourages users to seek the services of a professional engineer for any engineering advice they may require.