Automation

Automotive

Quality

Standing Inside a CMM with a Robotic Quality Scanning System

CMM are an important piece of manufacturing quality equipment. But when was the last time you stood inside one?

listen to this story

Shop-floor metrology can save time and cost compared to trips to the carefully climate controlled, carefully calibrated QC lab. But can it deliver the same results? In this video, Peter Martinez, global manager of strategic accounts at Creaform, explains why he and Jim are standing inside what’s effectively a massive CMM for large parts, such as castings, automotive parts, or large tooling.
Check out the video for more details.

Written by

James Anderton

Jim Anderton is the Director of Content for ENGINEERING.com. Mr. Anderton was formerly editor of Canadian Metalworking Magazine and has contributed to a wide range of print and on-line publications, including Design Engineering, Canadian Plastics, Service Station and Garage Management, Autovision, and the National Post. He also brings prior industry experience in quality and part design for a Tier One automotive supplier.