To ask an engineering question please visit our forum site at Eng-Tips.



Browse our archive of questions and answers below or to access our old forum database of over 10000 questions and answers please visit the old Ask@ forum.

Question for an elecrical engineer
Last Post 02 Mar 2015 09:28 AM by CDub. 0 Replies.
AddThis - Bookmarking and Sharing Button Printer Friendly
  •  
  •  
  •  
  •  
  •  
Sort:
PrevPrev NextNext
You are not authorized to post a reply.
Author Messages
CDub
New Member
New Member
Posts:1

--
02 Mar 2015 09:28 AM
    I am using a line voltage hot surface ignitor. I am using two 18 gauge wires to initially power and then to read a signal. I need at least a 1 micro-amp reading from the source, normally it will read from 1 up to 1.75 micro-amps. The wire are directly connected to the hot surface ignitor and then sealed from the factory and then I install pins that fit into a wire harness connector. The problem I have arises if the hot surface ignitor breaks and the wiring harness is not easily accessible. We can cut the wire, splice them, and use direct solder or wire nuts to make the connection. If we use butt connectors or some other type of connector the signal drops below an acceptable level, maybe it is increasing the resistance? If it is increasing the resistance would there be a connector that I could use that would allow the signal to flow freely?

    You are not authorized to post a reply.